Great Lakes 4x4. The largest offroad forum in the Midwest banner

SOLD - 2nd Gen Ram 2500/3500 D60 front (94-98ish) *reduced*

1K views 13 replies 5 participants last post by  PavementPounder 
#1 · (Edited)
Low-pinion, 3.54, CAD intact. This is the 8800lb GVWR front. Outers disassembled, but have all shafts, knuckles, and calipers. No unit bearings or rotors, but I have the used set of unit bearings off my Ram to supply in order to roll around on and I think I may have 1 unused/new factory rotor still in the box that I will include if I still have it.

$500. Available immediately.

Would go nicely with these knuckles to get away from the unit bearing configuration. You'd have to buy new unit bearings anyway, so you might as well use that money for spindles/bearings/hubs/rotors/lockouts instead. :thumb:


SOLD.
 
#9 ·
Exactly. I was just going to wait until a buyer that actually has money presents themself before I threw that at them. I might also just keep those for my Ram's new front D60 or sell them with the current D60 since both of those are also ball joint.
 
You have insufficient privileges to reply here.
Top