Great Lakes 4x4. The largest offroad forum in the Midwest banner

Mr. Beefy's "not quite yet U4 buggy" build

358K views 3K replies 117 participants last post by  Mr. Beefy 
#1 · (Edited)
Alright fine, I'll make a new build thread :finger: :sonicjay:

Bought a MandM offroad chassis from PJ, super good dude to deal with and super nice. HIGHLY recommend. http://mandmfab.com/id68.html
This is chassis #20

Order placed on Monday 11-5 at about noon..

Got this on 11-6.




11-9






11-12


11-13

 
See less See more
10
#164 ·
Need that ring to know where my tcase height will end up before i can get the motor set. I did make the mount bracket where it attaches to the block. Plan is to mount bushing at frame and connect to mount bracket on block with tube. Same with trans crossmember, bushings at frame on both sides of trans crossmember. Then an additional support for the tcase itself. Half ass threw the butchered eb dash in it. Looks like that shoild be easy to fit when i order a new blank dash.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top