Great Lakes 4x4. The largest offroad forum in the Midwest banner

intake manifold gasket's on a 4.2

632 views 1 reply 2 participants last post by  Yota Bill 
#1 ·
Has any one replaced intake manifold gasket's on a 4.2 v-6.

I picked up a 97 f-150 and I'm reading that they are know for going bad,and my truck burn's a little oil,and i read that these gaskets can cause this also.

So are they hard for the average backyard mech?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top