Great Lakes 4x4. The largest offroad forum in the Midwest banner

1994 Ranger code reading question

1K views 10 replies 5 participants last post by  greenmeanie 
#1 ·
I found the helpful page in the FAQ's about pulling codes, but am wondering how to read them.

Does the # of flashes of the CEL equal a digit in the code?

For example: would a code 123 be 1 flash:pause, 2 flashes:pause, and then 3 flashes followed by a long pause?

Thanks! -Kevin
 
#4 ·
I got the code pulled fine. AC was on during the test was the code (even though the blower was off and compressor unplugged).

Anyone know how to reset the codes and why this code would be flashing with everything AC related unplugged and off?

I have unhooked the battery already. Will unplugging the computer reset the code?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top