Great Lakes 4x4. The largest offroad forum in the Midwest banner

FS/FT Turn key CNC Plasma Cutter / Hypertherm / Mach5 / SheetCam

4K views 8 replies 2 participants last post by  brimy311 
#1 · (Edited)
We are selling our old 4' x 8' CNC Plasma Machine. We used this machine for nearly 4 years without issue and the machine is still under power and can be run. Reason for selling, we upgraded to a full production HD Plasma Cutter and table. We built the machine just over 4 years ago, we did not skimp on any parts. Asking $10,000 or trade! Razors or other cool things. Can be seen in Kalamazoo, Mi. Shipping would be TBD, FOB. Any questions, please email me Brian@jcroffroad.com or 269-806-6036

Features:
4' x 8' Water Table
Extruded aluminum gantry, with aluminum sides.
740oz-in steepers, two on the x axis (620 oz-in on the z)
Mach5 Controls (all of CNC&C controls and motors. Z Axis control with THC as well.)

PlazPak 1a
http://www.candcnc.com/PlasmaPakPriceChart.htm

Linear Rails and Bearings
Rack and Pinion drives with reduction boxes (belt driven)
Harbor Freight Dryer
Hypertherm 1000 Plasma Cutter w/ CNC Torch
Handful of Plasma consumables and such
Includes SheetCam License for Nesting

Linear Rails are 20mm
Bearings are HIWIN LGW20
http://www.automation-overstock.com/lgwspecs.asp

Z access has a magnetic release for the torch with a safety stop, but no other home or stop switches on the table, they can be added however.







 
See less See more
4
You have insufficient privileges to reply here.
Top