Great Lakes 4x4. The largest offroad forum in the Midwest banner
281K views 3K replies 91 participants last post by  jbsjunk 
#1 · (Edited)
This will finally get put together ! I'm looking at running a lot of the parts off my jeep plus some new cool stuff lolso as of now it will be on a 14 bolt rear four link a 60 front four linked full hydro . 16 inch rear 2,5 air shocks and 14 fronts. 2.5 four inch travel air bumps all four corners. aluminum lower links with 1.25 joints.44 cut boggers on 16.5 h1s.
built 92 fuel injected 302 running on e-85 with a c-6 and 205 combo. im ether going to run 1350 or 14xx drive shaft joints just not sure yet.it will have an artcar shifter and a jb fab twin stick kit. all the seats will be corbea with five point harnesses. im sure im missing something so I will update as parts come in !
 
See less See more
2
#1,288 ·

Exhaust is all wrapped and laying in place! Now it's drive train time!!!!!!!


Sent from my iPhone using Tapatalk
 
#1,289 ·

Strangler helped by putting on the fuel rail and some plumbing last night!


Sent from my iPhone using Tapatalk
 
#1,297 ·
Close its almost ready to drop the drivetrain in!


Sent from my iPhone using Tapatalk
 
#1,305 ·
not yet I need to find a night this week that I can get a hand to drop the drive train In! ................. can I use a few moving blankets of yours to put in the engine bay so I don't fuck it up?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top