I have a 2000 2500 Silverado. with the autotrac transfer case.
I want to pull the front driveshaft to see if the vibration is being caused by a bad front U-joint.
Once the 4 bolts are off the front of the shaft.....do these metal clamps and boot need to come off before it comes out?, or do they come out with the shaft?
and can I run it with the shaft out?
I just want to make sure I have extra clamps before I get into it.
Tx
- Tim
:thumb:
I want to pull the front driveshaft to see if the vibration is being caused by a bad front U-joint.
Once the 4 bolts are off the front of the shaft.....do these metal clamps and boot need to come off before it comes out?, or do they come out with the shaft?
and can I run it with the shaft out?
I just want to make sure I have extra clamps before I get into it.
Tx
- Tim
:thumb: