Anyone have any cermaic coating done around Detroit, Lansing, Jackson area? I am looking to have a turbo hot side coated inaide and out as well as the up pipes and down pipe. Anyone have any suggestions for places?
We've had a ton of stuff done by the guys below. Always had great results at a fair price, and turn around time has always been good. They've done numerous sets of headers for us, mufflers, pipes, turndowns, etc. http://www.qccoatings.com/
We've had a ton of stuff done by the guys below. Always had great results at a fair price, and turn around time has always been good. They've done numerous sets of headers for us, mufflers, pipes, turndowns, etc. http://www.qccoatings.com/
Everything we've had done has held up very well, but none of that has seen winter/salt. The only thing I've seen, is the exhaust dumps get dulled after time, but that has nothing to do with them. That's only because they are directly in front of our paddles/scoops, and get sand blasted constantly.
A lot of those coatings don't last at all. If the places mentioned above are good I'd go with them. I've had stuff done and it was suppose to hold up well and not rust and it rusted in about a week.
I second using jethot coating. We use them for our proto stuff at work and it holds up...very well. Ive seen turbine inlet temps of 725* C on some of the housings we have done and it doesnt flake.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Great Lakes 4x4. The largest offroad forum in the Midwest
4.2M posts
30.9K members
Since 2005
A forum community dedicated to Great Lakes 4X4 owners and enthusiasts. Come join the discussion about performance, trails, tires, modifications, classifieds, troubleshooting, maintenance, and more!