Great Lakes 4x4. The largest offroad forum in the Midwest banner

1985 Chevy Monte Carlo

1K views 8 replies 4 participants last post by  montecarlo33 
#1 ·
Feeler
For Sale: 1985 Chevrolet monte carlo, have owned the car since i was 14, recently bought an older camaro so it's time to sell the old girl.

Engine: Four bolt main 350 bored .030 (355 cubic inches) Has gm 010 high nickle block. Flat top speed pro hyperutectic pistons, good gm "pink" rods and a cast crank ground 10-10. The block has been zero decked and the heads have been milled .030. The heads are World products S/R Torquer haeds that have been ported and polished with 2.02/1.60 stainless manley valves. Has a speed pro cam 204/214 duration with .450/.470 lift an 1.6 ratio rocker arms. Has dynomax 1 5/8 ceramic coated headers, an edlebrock performer intake and 600 cfm carb. also has 3 inch exhaust with chambered race mufflers.

Trans: Rebuilt and beefed up TH350 rebuilt by frayleys in pontiac, has all hardened intermediate parts, Trans go shift kit, TCI 2000 rpm stall converter, +2 quart TCI trans pan and a hurst pro-matic shifter.

Rear end: Stock 3.08 posi rear end with new axle seals and new brakes, drums, shoes, wheel cylinders etc.

Car was repainted about seven years ago and is starting to show some age could use a few touch ups here and there. Engine and trans only have 6,000 miles on them always had synthetic oil.

Sorry no pics yet but will come soon. Car is located in clarkston, Asking 4,100 o.b.o (have more than that in drive train alone) Any rersponse is appreciated, thanks.
 
See less See more
You have insufficient privileges to reply here.
Top