|March 17th, 2014, 10:32 AM||#1|
1989 jeep wrangler for sale $7500
I have a very modified wrangler for sale.
Chevy 350 bored .040 over with vortec heads,dual plane intake,edelbrock 650 off-road carb,all arp bolts,msd ignition box,block hugger stainless headers.
Remote oil filter. Flowmaster 40 series muffler
Ax15 trans with center force conversion clutch and advance adapters bell housing. Hurst shifter.
Np231 t-case with sye kit and rear 1350 u-joints
Rear axle is a ford 9" with 4.56 gears moser full spool and 35 spline moser axle shafts plus a disk brake conversion.
Front axle is a salvage Cherokee high pinion 30 with 4.56 gears and Detroit true trac. New u- joints and ball joints when I installed it.
Tires are 33x13.50x15 super swampers tsl on aluminum rims
Quadra tec front tube bumper with shackles and mile marker 8k winch.
Drive shafts are by Tom woods
Also just put on a shackle reversal kit
Lift is a super lift 3.5" fronts have add-leaf to support the weight of the motor and winch. Total lift height is 5" with reversal and daystar lift shackles in the rear. Bilstein 5150 shocks and polyurethane bushings
Crown braided and sheathed brake lines plus a complete hard line kit from inline tube. Ford ltd master cylinder to support the rear disk conversion.
Dual optima red tops
Just replaced the soft top last summer.
All auto meter sport comp gauges in their clusters
Sony radio with 3.5mm jack and infinity 6x9 in the pods and Polk/Mormon 4x6 plates I the dash.
Upgraded to the family style roll bar with seat belts.
Replaced drivers floor pan and bed lined the whole inside.
Replaced the windshield and frame.
Bushwhacked fender flairs they are worse for wear.
Installed a 2013 camaro carbon fiber hood scoop which needs to be re done.
Aluminum radiator built by superior radiator with a aluminum shroud and 16" electric fan.
Has only on kc rectangular spot light but both windshield brackets are present.
There is a kill switch wired in and also a front port for plugging in trailer lights for flat towing.
The tailgate should be replace as it is splitting.
I also installed home made thick aluminum rocker guards.
There is also a cb installed just need the cable back to the antenna.
I know there is probably more but I can't remember at the moment. I have most of the receipts/documentation to go with everything. And also a 700r4 4x4 k case trans and a 1977 ford Dana 44 low pinion front housing that has already been narrowed to go with the sale.
If you are interested or have any questions please call or text me at(586)634-3743. Thanks for looking.[ATTACH]115061[/ATTACH]
Last edited by snow fighter; March 22nd, 2014 at 01:45 PM. Reason: Pics added
|Thread Tools||Search this Thread|