|December 10th, 2013, 09:46 PM||#1|
F150 Truggy Project
III'm selling my Truggy Project that I haven't touched in a while to try to get it out of my garage and make some room. Here are some basic specs of it:
HD Ford Dana 44 Front axle 4.10 gears
Chevy Outer knuckles
Blue Torch Fab High steer arms
1-ton steering ( 1.5x.250 D.O.M)
New ball joints, u joints, wheel bearings, hub seals, rotors, tie rod ends
Sterling 10.25 Rear 4.10's
Ruff Stuff Disc brake brackets
It has a 351W That was pulled out of another 3/4 ton that had a jasper short block in it with relatively low miles it ran when I drove it to pull the motor. I pulled all of the efi stuff off of the motor and it currently has a Edelbrock intake on it for a carb setup.
Front is a Y-link radius arm setup. Poly bushings are used axle end with johnny joints at the frame. Links are 2"x.250 D.O.M Y link uses a 1.25 chromoly heim.
Trackbar is 1.5x.250 with chromoly heims
F150 lift coils
Rear is single triangulated 4 link
2x.250 wall lower links with 1.25 chromoly heims and poly bushings
Uppers are 1.5x.250 wall links with 3/4 or 7/8 chromoly heims and poly bushings
Has a lot of odds and ends that go with it:
Bucket racing seats with padded covers
Aluminum Radiator from Northern Radiator
Ballistic Battery tray
Small OBA tank
2 Hurst shifters and random stuff that goes along with them. I bought it used, not sure what all is there.
5 Goodyear Military OZ 36" tires
There are a lot of other small odds and ends I am sure I am forgetting
1- 5 point racing harness
All of the tubing on the truck is all 1.75x.120 D.O.M. there are some odd ball 1.5 and 2" here and there but small amounts.
It needs a few main things to be a functional rig:
Brakes and lines
Carb/Dist with electric and plumbing ran
Driveshafts ( I have a few oddball stock parts for this)
Whatever I left out describing the truck still comes with it, like I said I haven't touched it in a while but the build thread is up to date on the truck of its progress.
$2200 located in Hope, MI 48628
$1500 without motor
May trade for something else 4x4, 4x4 quad, gas drive welder, larger mig welder, outboard boat motor.
Here is a link to the build of it better that will explain a lot better what it is
Last edited by jeepxj2007; January 5th, 2014 at 04:01 PM.
|January 9th, 2014, 07:42 AM||#16|
Join Date: 01-11-08
Mentioned: 0 Post(s)
I dont have an outboard motor but i may have a whole boat i will trade. Its a 1983 21' searay with cuddy cabin, newer intearior a new built 350 as of last sommer put it in the water last sommer for 10 min but the EB750 Carb was to big for the 350 and fluded it out. i have been restoring this boat for almost 4 years.
|Thread Tools||Search this Thread|