Go Back   Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Parts for sale
GL4x4 Live! GL4x4 Casino







Search
Reply
 
Thread Tools
Old November 3rd, 2013, 08:33 PM   #1
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Lots of Misc Jeep and Universal Parts

Twin stick shifter boot. Brand new but dirty from sitting around. $10


Chrome bumperettes. Used in good condition but need some easy cleanup. $10


TJ towhooks. 2 front, 1 rear. Could easily be adapted to other vehicles. $15


Used AMC V8 distributor with steel drive gear. Also a new in box steel drive gear. Came with my 401 but I never used it. $20 for both.


700R4 to NP241 adapter. 4 bolts at the trans, 6 bolt round pattern at the t-case(works with NP208, 231, 241, etc). Was going to use it for a custom setup and had to trim off one of the lower mounting feet. Still good to go, just needs some surface rust cleaned up. $10



Custom made aluminum spare tire hold down. Welded arms, machined aluminum cone center, threaded mounting shaft, removable Jeep emblem in the center.


Brand new CJ steering box brace. Complete with instructions and hardware. $20 sale pending


New speedometer cable. Originally purchased for 1972 Chevelle, will probably fit quite a few other vehicles. $10

Last edited by bbaXJ; November 5th, 2013 at 05:55 PM.
bbaXJ is offline   Reply With Quote
Old November 3rd, 2013, 08:39 PM   #2
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Small 12v compressor with attached tank. The compressor portion died, could be replaced or used for just the tank. I believe the tank is 3 liters. $10


CV driveshaft, I believe 1310 joints all around. Looks like most of it could use a rebuild, or a good cleaning at minimum. $10



Rancho steering stabilizer kit. Originally on an 80s CJ but looks to be a fairly universal kit. $20


4" intake pipe, elbows, and clamps. Came off a custom LS motor setup. 2 90deg elbows, 1 45deg elbow, and 1 flex elbow for whatever angle is needed. Nice stainless clamps. New parts are pricey for this setup. $50 for all


New in box black chrome(slightly darker than normal chrome) high quality stainless steel exhaust tip. 2.5" in, 3.5" out, 24" long. $20


TJ softtop header bar. Great condition. $20

Last edited by bbaXJ; November 5th, 2013 at 05:55 PM.
bbaXJ is offline   Reply With Quote
Old November 3rd, 2013, 08:46 PM   #3
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
All prices are OBO, all items located in Fowlerville or can be taken to Ann Arbor most weekdays. The more stuff you buy the better of a deal I'll cut you. I want this stuff gone.
bbaXJ is offline   Reply With Quote
Old November 3rd, 2013, 08:57 PM   #4
Defiance665
AKA "89Laredo"
 
Defiance665's Avatar
 
Join Date: 10-09-09
Location: Sanford, Michigan
Posts: 2,635
iTrader: (8)
Send a message via Yahoo to Defiance665
I'll take the cooler. Price shipped?
__________________
Quote:
Originally Posted by Nuggets View Post
I prefer the company of gentlemen.
Defiance665 is offline   Reply With Quote
Old November 3rd, 2013, 10:24 PM   #5
mandrews90
Senior Member
 
Join Date: 06-04-09
Location: howell mi
Posts: 157
iTrader: (6)
Call me about the bulkhead
Mike 810-343-2641
mandrews90 is offline   Reply With Quote
Old November 4th, 2013, 08:11 AM   #6
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Quote:
Originally Posted by Defiance665 View Post
I'll take the cooler. Price shipped?
PM sent
bbaXJ is offline   Reply With Quote
Old November 4th, 2013, 09:00 AM   #7
Swampbog
Senior Member
 
Swampbog's Avatar
 
Join Date: 02-28-10
Location: Garden city/Mich
Posts: 271
iTrader: (8)
I'll take the spreaders, gauges ( if they are 2-1/16), mirrors, tailgate, bodymount rubber, if you'll toss in the air cleaner assembly.

Sent from my SCH-I535
Swampbog is offline   Reply With Quote
Old November 4th, 2013, 09:29 AM   #8
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Quote:
Originally Posted by Swampbog View Post
I'll take the spreaders, gauges ( if they are 2-1/16), mirrors, tailgate, bodymount rubber, if you'll toss in the air cleaner assembly.

Sent from my SCH-I535
Deal
bbaXJ is offline   Reply With Quote
Old November 4th, 2013, 08:26 PM   #9
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Trans cooler and Scrambler bulkhead sold. Sale pending on tailgate, body mount rubber, mirrors, gauges, grill spreaders, and chrome air cleaner.
bbaXJ is offline   Reply With Quote
Old November 5th, 2013, 12:59 PM   #10
cannaert
Beer ME!
 
cannaert's Avatar
 
Join Date: 01-24-06
Location: Hartland/Fenton
Posts: 3,502
iTrader: (73)
Send a message via AIM to cannaert
Steerng box brace. I will take it, and the mirrors if they fall threw.
cannaert is offline   Reply With Quote
Old November 5th, 2013, 01:12 PM   #11
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Mirrors will probably be gone today but steering box brace is still available.
bbaXJ is offline   Reply With Quote
Old November 5th, 2013, 05:55 PM   #12
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Bump
bbaXJ is offline   Reply With Quote
Old November 10th, 2013, 10:04 AM   #13
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
All parts shown are still available
bbaXJ is offline   Reply With Quote
Old November 10th, 2013, 02:36 PM   #14
MTY Mouse
Senior Member
 
MTY Mouse's Avatar
 
Join Date: 03-19-08
Location: Shepherd MI
Posts: 391
iTrader: (8)
Best price on twin stick boot to 48883?
MTY Mouse is offline   Reply With Quote
Old November 12th, 2013, 12:35 PM   #15
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Bump

Quote:
Originally Posted by MTY Mouse View Post
Best price on twin stick boot to 48883?
Sorry I missed this. For the time being I'd rather not deal with shipping a single cheap part. If someone wants multiple parts I'll consider it, but I'd rather keep the shift boot around than hassle with shipping it alone.
bbaXJ is offline   Reply With Quote
Old November 18th, 2013, 08:57 PM   #16
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Still got everything listed above
bbaXJ is offline   Reply With Quote
Old November 25th, 2013, 01:34 PM   #17
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Bump
bbaXJ is offline   Reply With Quote
Old November 27th, 2013, 07:33 PM   #18
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
All still here
bbaXJ is offline   Reply With Quote
Old December 3rd, 2013, 12:10 PM   #19
bbaXJ
Yooper In Training
 
bbaXJ's Avatar
 
Join Date: 03-29-06
Location: Fowlertucky, MI
Posts: 4,447
iTrader: (59)
Send a message via AIM to bbaXJ
Bump
bbaXJ is offline   Reply With Quote
Reply
Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Parts for sale
Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT -5. The time now is 03:07 AM.


Powered by: vBulletin, Copyright 2000 - 2012, Jelsoft Enterprises Ltd.
Copyright 2005 - 2012 Cracker Enterprises - Powered by Linux
vB Ad Management by =RedTyger=
Page generated in 0.18209 seconds with 50 queries