Originally Posted by BigBlockBlazer
Make one, entry level fab at best.
If I had a welder and knew how to weld, I would. Realistically I need to make one because going from the 1piece rear main block to 2 piece rear main block it lacks a threaded hole on the passenger side cylinder head for the bracket to physically bolt to so I should come up with some sort of brace that utilizes that point.
Because right now without that bolted there, there is enough flex for it to half slip the belt: It hasn't come off... yet but every now and again it does this:
This is the bolt issue:
but again, no scrap metal laying around (beside a few incorrect braces for the aluminum brackets) and no way to weld
Originally Posted by snafu
I have them how close are you to harrison if you want to drive up you can have them
I'm at 696 and 75. Do you work elsewhere maybe I can meet up with you by there if its closer, otherwise it shouldn't be too far of a drive. PM me your cell phone number.