|June 23rd, 2013, 09:53 AM||#1|
expert jeep disassembler
Join Date: 08-28-08
Location: kent city mi
Mentioned: 12 Post(s)
Choosing tj coil springs
I don't like the stance my tj has and I was looking for some suggestions.
-Chevy 350 (iron heads)
- poison spider flat fenders front and rear
-35" mtr kevlars
-I believe they are 4.5" springs
I like the height that the front is at right now but the rear is almost 2" higher. I think a combination of the added weight up front and the larger diameter tubes on the 8.8 in the rear has caused it. I believe the front is at about 3.5" now after sagging.
I would like to find a spring manufacturer that could sell me springs that will be the compressed length that I want them to be. I would be fine with just replacing the rears to make them match the fronts if it would be possible.
What is my best route here besides coilovers?
Last edited by chadcooper55; June 23rd, 2013 at 07:35 PM.
|Thread Tools||Search this Thread|