|April 14th, 2013, 07:37 PM||#1|
Join Date: 04-27-10
Location: Muskegon, MI
Mentioned: 0 Post(s)
Wanted, possible use of a good bender, approx 4 bends needed
I am looking to line up someone that has a GOOD tube bender for a project I am thinking of doing this summer. I am looking into building my own radar arch/ rocket launcher set up on my boat. If you've never heard of such a thing it is like a roll bar on a boat where extra rods are stored up out of the way and a radar unit would be mounted.
I would only need four or maybe six bends in 2" tube. Something thin wall steel. Maybe 2" exhaust tubing would work. If you'd have a notcher that'd be a bonus as I'm thinking of welding up fixed rod holder's.
Right now this is just an idea I may want to build this spring/ summer. The boat is stored and covered up right now so I can't design it yet. If you have a tube bender and wouldn't mind helping with my project post up here or pm me. I'll gladly pay for a couple hours of your time or trade a case of beer.
I'm located in Muskegon, so closer the better in west Michigan the better. Maybe a 50 mile radius or so, Ludington to Holland to Grand Rapids or so.
Sent from the Garage
|April 14th, 2013, 08:32 PM||#4|
Join Date: 09-15-07
Location: fenton /hartland mi
Mentioned: 148 Post(s)
(mr.green)So you are calling CC a liar?? Not a nice way to treat your bitch.
tube bending and gear installs pm me for info! gears installed for $150 and up per axle.
|Thread Tools||Search this Thread|