|June 30th, 2009, 12:30 PM||#1|
98 Chevy Linked SAS
OK, This was my first major build and this is my first forum post I hope I figure out the picture uploads first time!
Before the axle swap my the truck looked like the photo below 4" suspension with a 3" body lift and 33's
Axles are out of a 79 F-250 HP Dana 44 front Dana 60 rear
Rear Suspension: Parallel 4 link with 4" Bronco Coils
Front Suspension: 3 link with 9" F-150 Coils
Links: 1 1/2" x 1/4" wall Dom, with 7/8" rod ends / poly bushings on other end
All brackets where made out of 3/16" and 1/4" sheet
35" Mickey Thompson MTZ's on 16" Mickey Thompson wheels
After about a year Its almost done. I still need to build my front driveshaft hopefully i will get around to it next week. Square tube cause I'm cheap like that.
Off with the IFS
My buddy Chad at the point of no return. Had to do alittle frame repair after this pic.
Rear frame link brackets
Rear Axle Trac Bar Installed.
Rear Axle with upper links in.
Front Axle getting ready to go back in I ended up having to redo the trac bar mount on the axle to correct the angle with the drag link
Cross member for the Front lower links
Front upper link mount
Front tire at max compression
My homemade sway bar links
Front Suspension all done
How she sits now many hours and cases of beer later.
|July 1st, 2009, 08:22 PM||#6|
Join Date: 11-18-05
that and build another truck...