|November 23rd, 2012, 09:55 PM||#1|
14ff and HP44, low miles since rebuild
I put all this stuff in the axles 1500 miles ago
4.88 Yukon gears f&r with new carrier in front for the gears
All new bearings and races
Rear has WFO caliper brackets and disc brakes, new calipers, new pads, new rotors
Front has new pads, new calipers, new rotors
New ball joints
New Warn lockouts
New wheel joints
WFO Diff covers front and rear
Both axles are open
Pass side knuckle was drilled and tapped by WFO for crossover
Rear perches are set up for 88-98 pad width, they are WFO perches
Only bad thing is the front is missing 1 wheel stud, D&R driveline assembled the axle and they were short one stud when putting it together and didnt tell me until I came to pick it up. I havent gotten around to fixing it yet.
Heres pics from when I built it showing the covers and such
The truck sat since spring of 11 so everything is a little dusty and the discs have some rust on them.
I have quit a lot into these, I'll start at $1500 OBO. PM me an offer, worst I can do is say no. Dont really want to sit on these all winter but I hate to lose my ass on them anymore than I already will.
|Thread Tools||Search this Thread|