d44 high/crossover steering arms, hardware, and knuckles
i have dana 44 crossover steering arms (both) and knuckles, and studs,cones, and nuts. hardware is new. arms are plain. arms are drilled to 3/4 inch on tie rod holes. crossover holes ar 5/8 with no taper. passenger knuckle is flat top. i did not have it machined. i ground it flat and drilled and tapped it. worked well on my ramcharger with no problems. asking 150 for all of it. just put in a dana 60 so i have no use for any of this.
Last edited by ssgtgaines; December 17th, 2012 at 04:00 PM.