2000 Cherokee XJ Part Out - Great Lakes 4x4. The largest offroad forum in the Midwest

Go Back   Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Vehicle Part Outs
GL4x4 Live! GL4x4 Casino

greatlakes4x4.com is the premier Great Lakes 4x4 Forum on the internet. Registered Users do not see the above ads.
Search
Reply
 
Thread Tools Search this Thread
Old May 30th, 2012, 04:32 PM   #1
Bullet
Senior Member
 
Bullet's Avatar
 
Join Date: 05-13-10
Location: Benton Harbor MI
Posts: 273
iTrader: (12)
Mentioned: 0 Post(s)
Default 2000 Cherokee XJ Part Out

Parting out a 2000 jeep cherokee. Hit hard in the right front.
No engine, transmission, t-case.

Partial list below:
Rear doors $50 each (Drivers Door Sold)
4.0l intake manifold 99 up $75
rear axle (no brakes) $100
fuel tank with pump $50
seats $30 full set.
Rear springs $25 pair SOLD
Dana 30 LP front axle parts
spindles, axles, carrier, gears....
Interior parts
Seats, headliner, center console, steering column, air bags, dash...
Rear hitch -small receiver
Body panels
Aftermarket sun roof
Quarter windows
Brake Clutch pedal assembly $30
Left side plastic wheel well trim $20
Windshield washer tank $25
Contact me for other parts not listed.







****I am looking for a 97 up Cherokee Non-AC Heater box and heater control.****

Last edited by Bullet; October 29th, 2012 at 01:53 PM.
Bullet is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old June 1st, 2012, 12:20 PM   #2
Clay
Fishin' rig
 
Clay's Avatar
 
Join Date: 03-12-08
Location: jenison michigan
Posts: 222
iTrader: (3)
Mentioned: 0 Post(s)
Default

Center console in good shape? how much
Clay is offline   Reply With Quote
Old June 1st, 2012, 03:17 PM   #3
Bullet
Senior Member
 
Bullet's Avatar
 
Join Date: 05-13-10
Location: Benton Harbor MI
Posts: 273
iTrader: (12)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by Clay View Post
Center console in good shape? how much
I have 2 of them. The first is in good shape, shown in the picture, latch for main lid and ash tray lids are broke $25

The second is decent, both ashtrays missing, no latch for lid and screw holes drilled in the side on the right of the shifter $10

Bullet is offline   Reply With Quote
Old June 1st, 2012, 04:12 PM   #4
Durt_Diver
Member
 
Join Date: 05-10-11
Location: Rochester Hills
Posts: 32
iTrader: (0)
Mentioned: 0 Post(s)
Default

rear leafs? rear end caps?

How much. pm me

edit: never mind, too far away
Durt_Diver is offline   Reply With Quote
Old June 6th, 2012, 05:11 PM   #5
Bullet
Senior Member
 
Bullet's Avatar
 
Join Date: 05-13-10
Location: Benton Harbor MI
Posts: 273
iTrader: (12)
Mentioned: 0 Post(s)
Default

Offers?
Bullet is offline   Reply With Quote
Old June 6th, 2012, 08:04 PM   #6
cheapcherokee91
"cant worry about it"
 
cheapcherokee91's Avatar
 
Join Date: 01-22-11
Location: downriver,mi
Posts: 296
iTrader: (1)
Mentioned: 0 Post(s)
Default

What gear ratio in the front. Need a 373 rind pinion. The whole axle ell work if the price is right
cheapcherokee91 is offline   Reply With Quote
Old June 7th, 2012, 08:24 AM   #7
Bullet
Senior Member
 
Bullet's Avatar
 
Join Date: 05-13-10
Location: Benton Harbor MI
Posts: 273
iTrader: (12)
Mentioned: 0 Post(s)
Default

Unfortunately its a 3.55 ratio. If you still need parts or pieces from it make an offer.
Bullet is offline   Reply With Quote
Old June 9th, 2012, 09:17 AM   #8
Chelsea-vong
Senior Member
 
Join Date: 09-26-10
Location: Cadillac, MI
Posts: 191
iTrader: (4)
Mentioned: 0 Post(s)
Default

How much for the front door seals as well as the rear hatch one?
Chelsea-vong is offline   Reply With Quote
Old June 9th, 2012, 09:38 AM   #9
Bullet
Senior Member
 
Bullet's Avatar
 
Join Date: 05-13-10
Location: Benton Harbor MI
Posts: 273
iTrader: (12)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by Chelsea-vong View Post
How much for the front door seals as well as the rear hatch one?
How about $15.
Bullet is offline   Reply With Quote
Old June 9th, 2012, 09:50 AM   #10
martianjeep
too broke to wheel
 
martianjeep's Avatar
 
Join Date: 03-29-09
Location: charlotte mi
Posts: 1,624
iTrader: (38)
Mentioned: 0 Post(s)
Default

were the rear springs sagging?
martianjeep is offline   Reply With Quote
Old June 9th, 2012, 12:47 PM   #11
Bullet
Senior Member
 
Bullet's Avatar
 
Join Date: 05-13-10
Location: Benton Harbor MI
Posts: 273
iTrader: (12)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by martianjeep View Post
were the rear springs sagging?
They were starting to....I think they had around 120k miles on them.
Bullet is offline   Reply With Quote
Old June 9th, 2012, 01:01 PM   #12
martianjeep
too broke to wheel
 
martianjeep's Avatar
 
Join Date: 03-29-09
Location: charlotte mi
Posts: 1,624
iTrader: (38)
Mentioned: 0 Post(s)
Default

how much for the hitch?
martianjeep is offline   Reply With Quote
Old June 9th, 2012, 10:42 PM   #13
Bullet
Senior Member
 
Bullet's Avatar
 
Join Date: 05-13-10
Location: Benton Harbor MI
Posts: 273
iTrader: (12)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by martianjeep View Post
how much for the hitch?
$25
Bullet is offline   Reply With Quote
Old June 10th, 2012, 07:50 AM   #14
joshcorey56
Senior Member
 
Join Date: 08-24-09
Location: beulah michigan
Posts: 213
iTrader: (0)
Mentioned: 0 Post(s)
Default

Still have the ecm and wiring harness for the motor? How much
joshcorey56 is offline   Reply With Quote
Old June 10th, 2012, 02:58 PM   #15
Bullet
Senior Member
 
Bullet's Avatar
 
Join Date: 05-13-10
Location: Benton Harbor MI
Posts: 273
iTrader: (12)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by joshcorey56 View Post
Still have the ecm and wiring harness for the motor? How much
I don't have the 2000 ecm and harness it sold with the motor, but I do have a 1999 ECM and engine wiring harness for $50.
Bullet is offline   Reply With Quote
Old July 8th, 2012, 11:00 PM   #16
Bullet
Senior Member
 
Bullet's Avatar
 
Join Date: 05-13-10
Location: Benton Harbor MI
Posts: 273
iTrader: (12)
Mentioned: 0 Post(s)
Default

Offers or trades?
Bullet is offline   Reply With Quote
Old July 17th, 2012, 04:58 PM   #17
butcyh cassidy
Senior Member
 
butcyh cassidy's Avatar
 
Join Date: 03-15-07
Location: vermilion oh
Posts: 687
iTrader: (0)
Mentioned: 2 Post(s)
Default

are all the door switches available?
butcyh cassidy is offline   Reply With Quote
Old July 21st, 2012, 11:14 PM   #18
Bullet
Senior Member
 
Bullet's Avatar
 
Join Date: 05-13-10
Location: Benton Harbor MI
Posts: 273
iTrader: (12)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by butcyh cassidy View Post
are all the door switches available?
Sorry been trying to find all of them, I only can find 2 left....
Bullet is offline   Reply With Quote
Old July 22nd, 2012, 05:35 PM   #19
butcyh cassidy
Senior Member
 
butcyh cassidy's Avatar
 
Join Date: 03-15-07
Location: vermilion oh
Posts: 687
iTrader: (0)
Mentioned: 2 Post(s)
Default

if you got the drivers master and the driver rear door that would be perfect.
butcyh cassidy is offline   Reply With Quote
Old July 27th, 2012, 11:19 AM   #20
GerkTJ
Senior Member
 
GerkTJ's Avatar
 
Join Date: 11-05-05
Location: ida, mi
Posts: 1,064
iTrader: (14)
Mentioned: 1 Post(s)
Default

you have a pm!
GerkTJ is offline   Reply With Quote
Reply
Great Lakes 4x4. The largest offroad forum in the Midwest > Great Lakes 4x4 Marketplace > Vehicle Part Outs

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:54 AM.


Powered by: vBulletin, Copyright 2000 - 2012, Jelsoft Enterprises Ltd.
User Alert System provided by Advanced User Tagging (Lite) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd. Runs best on HiVelocity Hosting.
Page generated in 0.26449 seconds with 81 queries