|July 16th, 2011, 02:41 PM||#1|
270psi triple expansion
Join Date: 09-06-08
Mentioned: 11 Post(s)
I am going to use some air ride (semi truck) seats in this jeep. But I don't want to use the "padded foam seats" because I want the ability to rinse the interior down with a pressure washer.
I am looking for a 2 piece plastic seat. I want high rise with a small area like a inch or so between the top of the bottom and the mounting system.
The space between the top and bottom will give a little bit of comfort over not having any padding at all. I will have removable (dry cleanable) padding to give a little comfort when driving buy want to be able to store that padding and have the interior mud caked off road.
Almost something like these seats is what I mean in the area between the bottom of the seat and the mounting surface.
These seats (^^^) are really expensive new when compared to other plastic seats and I would need to cut them (so they could recline) to make them work not to mention the plastic is not uv stable there for I will need to worry about the butt area (the weak point) cracking and filling up with water/sand.
All my interior electronics / gauges are above the drivers head (and the floor does not have that jeep shin hitting side to it) with the forethought of spraying down the interior.
I am asking what you would use as far as plastic seats. Whats good and what is junk?
|July 17th, 2011, 12:25 PM||#2|
Join Date: 11-08-05
Location: a mile from the shithole
Mentioned: 39 Post(s)
I just used old vans seats in my jeep, vinyl washes off nice and the foam does not get soaked even in a heavy rain. Or you could use boat seats.
|cerial, jeep, pj, project pj, seats|
|Thread Tools||Search this Thread|