|December 17th, 2009, 03:41 PM||#1|
Join Date: 03-19-09
Mentioned: 0 Post(s)
92 suzuki samurai second chance
okay to let u in on the title im on my second samurai. my first one was 500 dollars and ran good i did a spring over and rhino lined the whole outside and inside of it, but that wasn't enough so i put six inch lift springs on top of that how stupid can i get. to get to the point i rolled it a week later twice endo then sideways ouch.
on to round two i just can't get enough of these little guys. so my plans with the second one it is two wheel drive and has a blown head gasket.
so i have a parts samurai take the transfer case and axle and do a axle flip right away. then i know a really good engine builder who has very reasonable pricing so i rebuild the entire engine bore 30 over head milled 20 thounths so on and so forth. 31x10.50x15 and away we go.
right after the axle flip
right after the buzz bomb
right after i stick a tree through the windshield ouch hammers sure make things look like new
i will have pictures soon of the new add ons like lots of exocage and plasma cutter extended wheel base 4 link and much more to come.
sorry about the delay computer problems i have a few new pictures i got the plasma cutter in my hand and this is what happen.
this is after i decided to move my rear axle back a few inches
just a little rust no problem ill plasma cut it out
im going to cut the front out now and my first plan was to just cut out the fender flares and call it good but now i want to tube it all so i am doing what i can
it may not be the best thing uve ever seen but its my first project that has tube to bend and that kind of thing. so i am learnin and i thing im going to build something new after this what i dont know yet
Last edited by chevyman; December 24th, 2009 at 10:15 AM.