Great Lakes 4x4. The largest offroad forum in the Midwest banner
281K views 3K replies 91 participants last post by  jbsjunk 
#1 · (Edited)
This will finally get put together ! I'm looking at running a lot of the parts off my jeep plus some new cool stuff lolso as of now it will be on a 14 bolt rear four link a 60 front four linked full hydro . 16 inch rear 2,5 air shocks and 14 fronts. 2.5 four inch travel air bumps all four corners. aluminum lower links with 1.25 joints.44 cut boggers on 16.5 h1s.
built 92 fuel injected 302 running on e-85 with a c-6 and 205 combo. im ether going to run 1350 or 14xx drive shaft joints just not sure yet.it will have an artcar shifter and a jb fab twin stick kit. all the seats will be corbea with five point harnesses. im sure im missing something so I will update as parts come in !
 
See less See more
2
#390 ·
deal! I will bring it over when I get it and we can have a beer or ten and throw it on:thumb:
 
#393 ·
yes I could use a hand! maybe even see if mr green can come also ? I could use a hand setting up my links
 
#409 ·
I'm doing this like I did when I built my jeep. I'm getting all the parts before I go at it haha


Sent from my iPhone using Tapatalk
 
#414 ·
well I got half the tabs and brackets cut off of the front axle yesterday now to get the rest and then grind my life away . hahaha pics coming soon !
 
#420 ·
Well I got most everything cut off and ran out of fire wrench fuel haha



Sent from my iPhone using Tapatalk
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top