Yes I found my tool bag. It slid under the back seat. Kinda hard to figure out how a bag 4" in diameter slid into a 2" slot. Dumbo me.
I also need to clean and oil my hi-lift. Used it 3 times today.
something about that 1st section of the woods course. I have been nothing but happy with my mtrs til today. they just would not bite in the woods course. the seem to crawl everything else just fine.
Broke:
Pride
2.5" radflo coilover
both d-shafts are super shiny and dented
something went boom in my front end. either axle shaft or hub.
I hope santa comes and brings me the parts I need to go to snofari
Great time! I had to do a Meijer run first, so I didn't get there until 130pm. Did my test passes, got multiple air on the last one, thought I was going to break everything!
Did rocks a bunch, had a blast.
My breaks were limited to a misadjusted doubler shifter (again, going to make different completely now) had to do the rocks in standard low range. Broke a piece of plastic off my hub switch.
DansTJ watched me almost break my leg when my foot slipped off the damn fourwheeler at the end of the small rock hill:fish:
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Great Lakes 4x4. The largest offroad forum in the Midwest
4.2M posts
30.9K members
Since 2005
A forum community dedicated to Great Lakes 4X4 owners and enthusiasts. Come join the discussion about performance, trails, tires, modifications, classifieds, troubleshooting, maintenance, and more!