SOLD
Have a stock 85 Bronco for sale. Not sure what is good on this truck. EFI 302, C6, NP205 (I think). Most of the Body panels are in good (low rust) shape including doors and hood. Front pass fender is dented prevents door from opening. Floor board on driver side rusted out completely. All glass is intact, top is in good shape.
I do not know if the trans or Tcase are any good, it's been sitting a while. The engine, I would NOT expect to get running without a full rebuild. It was running rough when parked and while working on trying to get it running right had an engine fire, melted the wire harness to injectors and some other parts. Injectors are not installed and holes filled with paper towel (I didn't do this oke
IFS front and I believe a 9" rear (1/2 ton?)
If I had the time I would part it out, I don't. I'll ask $250, don't be shy, the GF wants this GONE!
rusted out floor board
SOLD
Have a stock 85 Bronco for sale. Not sure what is good on this truck. EFI 302, C6, NP205 (I think). Most of the Body panels are in good (low rust) shape including doors and hood. Front pass fender is dented prevents door from opening. Floor board on driver side rusted out completely. All glass is intact, top is in good shape.
I do not know if the trans or Tcase are any good, it's been sitting a while. The engine, I would NOT expect to get running without a full rebuild. It was running rough when parked and while working on trying to get it running right had an engine fire, melted the wire harness to injectors and some other parts. Injectors are not installed and holes filled with paper towel (I didn't do this oke
IFS front and I believe a 9" rear (1/2 ton?)
If I had the time I would part it out, I don't. I'll ask $250, don't be shy, the GF wants this GONE!
rusted out floor board
SOLD