Hey all the Jeep is gone, Before we donated it I pulled the homebuilt Steel bumper off it. Bumper was built by a friend a couple years back. And has taken a decent amount of abuse.
Was mounted to a 97 ZJ with a 96 ZJ front clip. Will fit early zjs best, but with some welding you could fiill the voids under the head lights to fit a 97-98.
It needs a good sand blasting and some tender love and paint care.
It is very heavy.
It mounts up using a Tie in bracket like a XJ that slips inside the unibody frame rail.
You will need to source H2/3 Shackles to make the tow points work. The holes are too close to the body of the bumper to accomodate standard clevis shackles.
Oh yea. located in Downtown Rochester. NE Oakland County. I can and will meet within reason to deliver it for a reasonable offer.
$175 now $110
Dimensions...Bumper is
65.5 inches wide.
17in. from front face to the back of each side piece.
6in tall in the center
4 inches tall at the outer edges and then tapering towards the back.
Each mounting bracket (which are thru welded and include the d ring tabs. are 1/2 inch thick and 8 inches long(measured from the back of the bumper back.).
The brackets measure 32.5 inches apart (outside facing edge to outside facing edge) and each is inset from the side 16 in.
Each bracket is also 3.25 in tall.
Was mounted to a 97 ZJ with a 96 ZJ front clip. Will fit early zjs best, but with some welding you could fiill the voids under the head lights to fit a 97-98.
It needs a good sand blasting and some tender love and paint care.
It is very heavy.
It mounts up using a Tie in bracket like a XJ that slips inside the unibody frame rail.
You will need to source H2/3 Shackles to make the tow points work. The holes are too close to the body of the bumper to accomodate standard clevis shackles.
Oh yea. located in Downtown Rochester. NE Oakland County. I can and will meet within reason to deliver it for a reasonable offer.
$175 now $110
Dimensions...Bumper is
65.5 inches wide.
17in. from front face to the back of each side piece.
6in tall in the center
4 inches tall at the outer edges and then tapering towards the back.
Each mounting bracket (which are thru welded and include the d ring tabs. are 1/2 inch thick and 8 inches long(measured from the back of the bumper back.).
The brackets measure 32.5 inches apart (outside facing edge to outside facing edge) and each is inset from the side 16 in.
Each bracket is also 3.25 in tall.