Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Our Panhard / Trackbar brackets, Variations......
View Single Post
Old March 13th, 2008, 07:04 PM   #1
Gravel Maker
Steel Hauler
Gravel Maker's Avatar
Join Date: 10-29-07
Location: Sacramento (Rubicon) Ca
Posts: 1,019
iTrader: (6)
Mentioned: 1 Post(s)
Thumbs up Our Panhard / Trackbar brackets, Variations......

We make 4 different Panhard / Trackbar brackets and I get alot of questions as to why not just 2?

Here is the simple answer. You are either replacing a weak factory bracket that has broken and need something stronger and more versatile or you are swapping a new axle into your rig and need something that works better or is more adaptable.

We make 2 for the axle end and 2 for the frame end. In this pic, from the top left (going clockwise) we have the Axle Offset Bracket because 70-80% of the time you need the additional room on the axle. Next we have the Axle Centered Bracket for those of you that can work with one, both have 3 height adjustment positions. The lower right shows the Frame Outside Bracket for those of you going full width and to the left the Frame Inside bracket for the relatively stock width axle. The Frame brackets both have 2 mounting positions so matching up is easy.

Remember, Selection is always the key!
Dan Fredrickson
Your Fabrication Parts Source

The New Industry Standard!
Gravel Maker is offline   Reply With Quote
Page generated in 0.15391 seconds with 22 queries