Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Chain saws in the mounds?
View Single Post
Old February 25th, 2008, 07:52 AM   #32
clarkstoncracker's Avatar
Join Date: 11-03-05
Location: OC - MI
Posts: 42,879
iTrader: (40)
Mentioned: 221 Post(s)
Send a message via AIM to clarkstoncracker

Originally Posted by whiterhino View Post
I walked a trail for a good 300-400 ft Saturday. Pretty cool but it had overhangers 4" diameter that were only 4 ft off the ground. It would take a couple guys at least an hour to clear it.

There are also a ton of potential hill climbs that can't be accessed.
We should pick a date and go back there to clean out that ravine. If we clear out some of those dead trees laying horizontal across there, and remove 10-12 smaller trees, that would be an absolute riot back there.

It would open up 1000' of new trail.

Where I had to stop pointing towards that other trail, we could also clean that out as a bypass to going over that peaked hill that everybody broke on.
clarkstoncracker is offline   Reply With Quote
Page generated in 0.13124 seconds with 22 queries