Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - winch controller relocation
View Single Post
Old January 1st, 2008, 06:34 PM   #4
Motor Slut
I put the Ick in Dick.
 
Motor Slut's Avatar
 
Join Date: 11-10-05
Location: 49963
Posts: 2,411
iTrader: (0)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by swampjeep View Post
well, figured it out, the switch was mounted by copper tabs going out to the cable contacts on the end of the motor, loosen then, the the switch slid right off, the cables were long enought to mount this switch to the fender and cut the cables and rout them from the copper tabs back to the motor so everthing still works. It's easy enough, I would do some pics and a quick write up, but since this winch is discontinued, I bet most people already have them set up how they want. I did hear these switches tend to burn out, so if it does, then I'll do the solenoid pack set up...
If you ever have to do an upgrade don't buy anything with the Warn name on it. That stupid grey switch is about $85 from Warn and the solenoid upgrade is $130. There are cheaper solutions if you look for them.
Motor Slut is offline   Reply With Quote
 
Page generated in 0.04515 seconds with 20 queries