Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - machine shop work
View Single Post
Old December 11th, 2007, 12:24 PM   #8
CheapThrillB2's Avatar
Join Date: 09-06-06
Location: Middleville, MI
Posts: 33,455
iTrader: (63)
Mentioned: 42 Post(s)

i didn't have any problems with the shaft until i put the lo-unit in lo and the tcase in high, i busted two shafts before i learned i shouldn't have done that

that shaft was keyed and welded, it broke at the welds
CheapThrillB2 is offline   Reply With Quote
Page generated in 0.05527 seconds with 21 queries