Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Roll Cage Design Website
View Single Post
Old December 9th, 2007, 10:04 AM   #6
Tab
Senior Member
 
Tab's Avatar
 
Join Date: 11-05-05
Location: Freeland, mi
Posts: 4,800
iTrader: (29)
Mentioned: 3 Post(s)
Default

Actually it looks like it held up fairly well for a 50mph side hit. It shifted because it could have used an angled piece from the top corned near the drivers head down to the lower corner bellow the passengers butt. If rolled off road I think it would have certainly saved your life and probably not shifted as much unless it was a very hard roll on rock. Also, cages are meant to be replaced after a hard roll anyway so it would have served its purpose. Not to sound like im on pirate but all it needed was more trianglulation.
Tab is offline   Reply With Quote
 
Page generated in 0.03973 seconds with 20 queries