Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Ranger Solid Axle Swap
View Single Post
Old March 14th, 2006, 08:07 PM   #12
Senior Member
chris1044's Avatar
Join Date: 11-05-05
Location: Lost in the mitten!
Posts: 2,065
iTrader: (5)
Mentioned: 1 Post(s)

The coil buckets wont fit the proper springs that will fit on the axle mounted spring perch. They're also dont have the proper shock set up if I'm not mistaken....

The radius arms for the TTB axle are entirely different than the radius arms for a SAS set up - that's what I was getting at (different in design where they attach to the axle - not different in function). As far as the crossmember being trimmed, I'm not talkign about the drop brackets for the TTB beam pivots, I'm talking about the crossmember must be trimmed....i'll try to find pics, but envision the crossmember the TTB pivots are bolted to. It's huge, and welded in know it's basically U channel bent into the shape to cradle the engine....well the front part of the U has to be cut off, otherwise the track bar binds with it when it's rubbing.....
chris1044 is offline   Reply With Quote
Page generated in 0.14640 seconds with 22 queries