Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - How to: Tj/Xj/Yj 30 with 44 knuckles
View Single Post
Old November 14th, 2007, 02:05 PM   #1
Jeepaholic
Axle Guru Extraordinaire
 
Jeepaholic's Avatar
 
Join Date: 04-08-06
Location: Owosso
Posts: 7,309
iTrader: (116)
Mentioned: 2 Post(s)
Send a message via AIM to Jeepaholic Send a message via MSN to Jeepaholic
Default How to: Tj/Xj/Yj 30 with 44 knuckles

Though I would do a write up of sorts on the dana 30 I built.

The goal was to use all easy to get parts, IE stock tj inners. But to also have high steer and lockouts. And not have to build another truss for the driver side uca :stan3: . Started out as a Xj hp 30, you will also need a cj dana 30 for tubes and inner C's, and dana 44 knuckles and hubs.

First cut these off


I used the shafts to measure for the amount of tube I needed to leave on the CJ dana 30 knuckles


Cut




Doing the other side


Mocked up


I used 2" 1/8" wall dom as a internal sleeve




One side done


Just a couple of brackets left to weld on.

Last edited by Jeepaholic; January 14th, 2009 at 01:19 PM.
Jeepaholic is offline   Reply With Quote
 
Page generated in 0.06090 seconds with 20 queries