Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - XJ Rear Bumber New Finished Pics
View Single Post
Old November 6th, 2007, 09:05 PM   #13
Pre4runner
Bike Dude
 
Pre4runner's Avatar
 
Join Date: 11-07-05
Location: Kawkawlin, mi
Posts: 2,098
iTrader: (14)
Mentioned: 0 Post(s)
Send a message via AIM to Pre4runner
Default

The pivot is off set so that when you open it and then open the hatch you can clear the tire.

I didn't think of this the first time... and can barely clear a 33" tire plus the somewhat centered problem.

i used a simple pipe set up and pin for a latch but it makes some noise once it runs out of grease, a nice squeak to remind you. I will be making a new one soon with driver side mount for a 36" and full width swing to mount the highlift, jerry can and cb antenna too

http://www.greatlakes4x4.com/showthread.php?t=51673
Pre4runner is offline   Reply With Quote
 
Page generated in 0.18702 seconds with 20 queries