Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - XJ Rear Bumber New Finished Pics
View Single Post
Old November 2nd, 2007, 06:30 AM   #10
comanche38
Senior Member
 
comanche38's Avatar
 
Join Date: 02-24-06
Location: Highland, Mi.
Posts: 704
iTrader: (21)
Mentioned: 0 Post(s)
Default

Yes, use the trailer spindle and bearings. I use to make them with a pivot point like you described, it worked great for a while and if you removed it often and cleaned and lubed it, it was great, but if not, good luck opening and/or removing the tire carrier. We had to cut the one off of my brothers when we replaced it with a spindle/bearings. I did like that it would stay in any position the way it was, with the bearings it almost opens too easily. You have to watch it. A tire on a swingout can do some damage. haha Nice bumper though.
comanche38 is offline   Reply With Quote
 
Page generated in 0.05586 seconds with 20 queries