Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - XJ Rear Bumber New Finished Pics
View Single Post
Old October 31st, 2007, 05:58 AM   #7
badazzamc
Get Some
 
badazzamc's Avatar
 
Join Date: 11-06-05
Location: Swartz Creek Mi
Posts: 4,221
iTrader: (24)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by ddeadserious View Post
I was thinking it'd make the most sense to have the hinge be on the driver side by the taillights, apparently Detours USA thought differently, but when I do mine, the hinge will be on the drivers side so there's not too much leverage on it.

What were you planning on using for a hinge?
I was thinking a 1" round stock with a something machined to fit over it, with some type of grease fitting in it.
badazzamc is offline   Reply With Quote
 
Page generated in 0.05291 seconds with 20 queries