Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - best TC steel supply?
View Single Post
Old October 18th, 2007, 04:37 PM   #7
dngrous_Jeep
National Guard guy
 
dngrous_Jeep's Avatar
 
Join Date: 09-10-06
Location: South Boredom, MI
Posts: 1,061
iTrader: (3)
Mentioned: 0 Post(s)
Default

Depending on what the application at the time is, I may do like Sam did on his front bumper and weld the angles rather than bend.

Until I hear a convincing reason to only use round tube, I don't see any negative issues with using box tubing, either?
Positives in my mind are, A) Easier to calculate the miter on angles, B) easier to cut angles with basic tools [angle grinder with cutoff wheel, miter saw with fibre disc, etc...], C) It's what I know, and am familar with.
dngrous_Jeep is offline   Reply With Quote
 
Page generated in 0.05233 seconds with 20 queries