Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - timing chain cover gasket
View Single Post
Old October 16th, 2007, 08:02 AM   #5
bj house
Senior Member
 
bj house's Avatar
 
Join Date: 06-02-06
Location: Auburn Hills, MI
Posts: 5,289
iTrader: (4)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by Hackfabrication View Post
What he said ^...If the leak is between the timing cover and the block, you're going to have to pull the balancer to remove the timing cover. When you get the gasket kit it will have a new crank seal. Do it right, and replace your old one when you put it all back together. Torque wrench is your friend.

Ford also had a habit of using Metric head fastners with SAE threads (5/16-18) on certain areas. I can't recall the exact size (IIRC 10mm?), but I replaced all of mine with ARP products. Except for the two 'special' bolt/studs used for accessorie mounting:



Of course, it's much easier to do with the motor out of the vehicle .
Hack Fab no more pictures of your garage. It is way too clean and your compressor could be a little larger :tonka:
bj house is offline   Reply With Quote
 
Page generated in 0.05944 seconds with 20 queries