Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Bolt strength question
View Single Post
Old October 8th, 2007, 07:30 PM   #4
nd4spd71
Senior Member
 
nd4spd71's Avatar
 
Join Date: 10-27-06
Location: Hastings, MI
Posts: 4,187
iTrader: (9)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by 95geo View Post
yes, just make sure they are torqued properly and the holes arent oversized too much
Where would I find the torque specs for them? If I remember right the holes are .550 so I should be good there.
nd4spd71 is offline   Reply With Quote
 
Page generated in 0.05397 seconds with 20 queries