Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Building Tube Fenders **LOTS OF NEW PICS ADDED 3/25/06**
View Single Post
Old March 2nd, 2006, 10:27 PM   #7
Buggy_Tim
(513) 891-8372
 
Buggy_Tim's Avatar
 
Join Date: 11-05-05
Location: Sault Sainte Marie
Posts: 11,823
iTrader: (12)
Mentioned: 3 Post(s)
Default

HAHA....I'll see if I can get a set. It was more an excercise for the drafting kids...the welding teacher and I are mostly doing this in our head and on the dry erase board. We are adding a little step area and a light tab.

We're bending the tube with a huge ass old bender. I'll have to take a pic for ya. It's something welding had over there. Thing weighs about 500 pounds. Needed a fork lift to get it on the table.

The tube is 1 inch OD tube. I was going to use the 1.25 tube like all the other places make them out of untill I had the 1.25 in my hands and felt it was too big for my liking so we went with a little smaller. I really like the size of the tube.
Buggy_Tim is offline   Reply With Quote
 
Page generated in 0.06076 seconds with 20 queries