Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Trans cross member ?s PICS ADDED
View Single Post
Old September 10th, 2007, 10:19 PM   #1
Senior Member
greenjeep's Avatar
Join Date: 01-03-06
Location: Wateford, MI
Posts: 393
iTrader: (7)
Mentioned: 0 Post(s)
Default Trans cross member ?s PICS ADDED

I built a new trans crossmember that has the trans bolted solid to a 3/8" plate. I then have tubing going out to the frame. I fishmouthed and welded a couple of pieces of pipe in a "T" that some spring bushings I had laying around fit in. Welded a couple of tabs to the inside of the frame. bolted the bushing part of xmember into tabs on frame.

So great, I now have a pretty flat belly on my Jeep. Now a guy at work that I showed my xmember to said " is that going to flex enough? if not you might crack/break your trans case "

I was really happy about my work, until the guy said that. So now I am worried about that. Has anyone ever done this before? I swear I have seen a factory xmember like this on a Ford before (mustang, ranger??).

I will try to post some pics later.


Last edited by greenjeep; September 12th, 2007 at 07:51 PM.
greenjeep is offline   Reply With Quote
Page generated in 0.18536 seconds with 22 queries