Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Where Is This Knock Coming From?!
View Single Post
Old September 10th, 2007, 03:43 PM   #8
chris1044
Senior Member
 
chris1044's Avatar
 
Join Date: 11-05-05
Location: Lost in the mitten!
Posts: 2,027
iTrader: (4)
Mentioned: 1 Post(s)
Default

Quote:
Originally Posted by Drg racr View Post
I'm pulling the motor this week. I have most of the stuff out of the way. But, I can't get to some of the belhousing bolts, or the TC bolts. Any ideas?
Bell housing bolts: you can get them all with a long (talking 24"+) extension and going in through back by where the T-Case is mounted. However, I like to get the top two by lying on the motor and using a stubby wrench.

TC bolts: After the trans is loose, like able to be pulled 1/2" away from the engine, I swear that bell housing cover can be taken out but its been a few years...you got to get the trans off the dowel pins so the cover can come off them as well. You can do this, or just get the TC bolts through the hole cut into the bell housing cover for the starter......
chris1044 is offline   Reply With Quote
 
Page generated in 0.05442 seconds with 20 queries