Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - camber/caster bushings
View Single Post
Old August 27th, 2007, 09:18 PM   #9
CheapThrillB2's Avatar
Join Date: 09-06-06
Location: Middleville, MI
Posts: 33,239
iTrader: (63)
Mentioned: 41 Post(s)

Originally Posted by 88fordman View Post
just drive it between the base and the bushing. good luck getting the pinch bolt out. recessed 12 point head....grrrrrrrrr!!! This is only on the D35, the D28 uses the ball joint castle nut to hold the bushing in i used a bolt out remover and it did the trick. then i replaced them with grade 8 allen bolts. do you have access to a rack or are you just doing a driveway alignment? because if your doing it the right way there is a chart that will tell you which slugs you need for X amount of caster change etc etc.
but first you need a reading.
oh yeah and on a side note when i hit mine with the air hammer they popped right out :)
CheapThrillB2 is offline   Reply With Quote
Page generated in 0.05915 seconds with 21 queries