View Single Post
Old August 26th, 2007, 09:35 PM   #6
chris1044
Senior Member
 
chris1044's Avatar
 
Join Date: 11-05-05
Location: Lost in the mitten!
Posts: 2,011
iTrader: (4)
Mentioned: 0 Post(s)
Default

Quote:
Originally Posted by CheapThrillB2 View Post
air hammer with chisel bit
X2 - all you do is loosen the top ball joint pinch bolt, take the air hammer and put it on the camber cam, pull the trigger, and work it in an upward fashion. It should pop right out - then put the new cam in, and you're off to some alignment fun.
chris1044 is offline   Reply With Quote
 
Page generated in 0.04040 seconds with 11 queries