Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - main, rod bearings, timing chain set, gasket help....
View Single Post
Old August 21st, 2007, 01:45 AM   #10
Plato2k5
In Da Faaaaaace!!!
 
Plato2k5's Avatar
 
Join Date: 12-25-05
Location: WMU Kzoo Mi / Livonia, MI
Posts: 5,445
iTrader: (17)
Mentioned: 1 Post(s)
Send a message via AIM to Plato2k5
Default

heads are stock '88 w150 think they are 68cc stock....will check the casting number than CC them. Also had some porting done.

Intake is a Edelbrock RPM dual plane intake

cam is going to be comp cams extreme cam and lifter kit p/n cl20-222-3

Duration at 050 inch Lift: 218 int./224 exh.
Valve Lift with Factory Rocker Arm Ratio: 0.462 int./0.470 exh. lift
Lobe Separation (degrees): 110
Grind Number: CRS XE262H-10
Lifter Style: Hydraulic flat tappet

Pistons are speed pro Hyp. h116cps

Block is bored .030" over

2-2,500k RPM stall

4.56 gearing
Plato2k5 is offline   Reply With Quote
 
Page generated in 0.04374 seconds with 20 queries