Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - School me: Tooling for milling machine...
View Single Post
Old August 10th, 2007, 05:20 PM   #4
Rocky
AAA GOLD ROCKS!!!!!
 
Rocky's Avatar
 
Join Date: 11-05-05
Location: Macomb
Posts: 8,512
iTrader: (13)
Mentioned: 1 Post(s)
Default

I would start with a clamp set, a machine vise, a set of parrallels, dial gauge to tram in the head is a must, an edge finder, collet set (I don't see the need for a chuck), a set of cheap HSS cutters (till you lnow your speeds and feeds), and maybe a fly cutter if you plan on cutting down a large surface area. Also, some quality collant. As you use it more you might what to buy a set of ruffing end mills and some ball end mills as needed.
Rocky is offline   Reply With Quote
 
Page generated in 0.06501 seconds with 20 queries