Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - School me: Tooling for milling machine...
View Single Post
Old August 10th, 2007, 01:17 PM   #1
Haggar
Covered in mud...
 
Haggar's Avatar
 
Join Date: 11-06-05
Location: Oxford, MI
Posts: 17,796
iTrader: (58)
Mentioned: 4 Post(s)
Default School me: Tooling for milling machine...

I just ended up with a mill, so I need to get some tooling.

For general fab / 4x4 stuff, what do you guys think is a good set of cutters to start with? (Like, say you had to name your 5 favorite cutter bits..what would they be?)

Anything else I should consider a must-have?

I have no tooling for it, actually I need a new cross slide X/Y table as well.
Haggar is offline   Reply With Quote
 
Page generated in 0.06135 seconds with 20 queries