Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Stupid compression cone thingys on steering arms. How to remove? dana44/10bolt
View Single Post
Old July 31st, 2007, 01:08 AM   #11
Monkeyevil
I <3 Miatas
 
Monkeyevil's Avatar
 
Join Date: 11-05-05
Location: Kalamazoo, MI
Posts: 8,988
iTrader: (16)
Mentioned: 3 Post(s)
Send a message via AIM to Monkeyevil
Default

If I am not re-using the studs and nuts I usually thread the nut on halfway, weld the nut to the stud, and pull the whole stud out.

If you plan on trying to re-use your studs you will have to hammer all around the arm to break the cone washers loose. Heat works great too.
__________________
JcrOffroad
Zoom Zoom!
Monkeyevil is offline   Reply With Quote
 
Page generated in 0.06358 seconds with 20 queries