Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - Killer B - Need Dana 60 torque specs
View Single Post
Old July 28th, 2007, 01:07 PM   #2
KILLER"B"468's Avatar
Join Date: 11-06-05
Location: Hendersonville Tn.
Posts: 7,945
iTrader: (19)
Mentioned: 2 Post(s)

sorry so late but better than never...

I torque the inner nut to 45 ft lbs and back the nut off a 1/4 turn. Then install the flat washer with holes in it , or the one with spider legs. Than I torque the outer to 60 ft lbs.
being on the eastern edge of the central time zone gets dark WAY to early.

Originally Posted by jeepbrattt View Post
An occasional jello or vasoline wrestling match isn't out of the question either.
KILLER"B"468 is offline   Reply With Quote
Page generated in 0.20713 seconds with 22 queries