Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - question about conrtol arm manufacturing?
View Single Post
Old July 25th, 2007, 03:45 PM   #35
Covered in mud...
Haggar's Avatar
Join Date: 11-06-05
Location: Oxford, MI
Posts: 17,916
iTrader: (59)
Mentioned: 9 Post(s)

Originally Posted by Bones View Post
My uppers are 1 1/2", 1/4" wall DOM

My lowers are 1 3/4, 3/8" wall DOM

I bent my lowers on the maiden voyage....
Was it bent somewhat smoothly, or kinked/dented?

FYI, 2.0" x 0.25" is about 15% stronger than 1.75" x 0.375" wall, in a bending moment, and almost 1 lb lighter per foot. Diameter makes a HUGE different in bending moment.
Haggar is offline   Reply With Quote
Page generated in 0.18309 seconds with 22 queries