Great Lakes 4x4. The largest offroad forum in the Midwest - View Single Post - question about conrtol arm manufacturing?
View Single Post
Old July 25th, 2007, 10:20 AM   #22
Senior Member
rockrat's Avatar
Join Date: 10-15-06
Location: Lake City, MI
Posts: 1,908
iTrader: (15)
Mentioned: 0 Post(s)

Originally Posted by 95geo View Post
great! you spent more than what a dom would have cost! how strong are your link MOUNTS?

thats fantastic that you overbuilt the shit out of your lower control arms, now how about the rest of the truck?

balance and weight conservation are key
figure out the cost of DOM, plugs, brackets, coils, springs, shocks and brakes and let's see who's is more expensive. As far as I see it, most of you can talk alot of bull, but ther's a few who can back it up. My geometry is correct, as I'm the 3rd in my club that has this set up; I'm just cheaper and stout. With 1000.00 mortgage gotta do what cha gotta do.

The frame rails are boxed 3/16" upper arms 2" soild also with 2.5" johnny joints off old lift. The only concern is with the full time case-the next to go.
rockrat is offline   Reply With Quote
Page generated in 0.14051 seconds with 22 queries